NARDA FieldMan User Manual

7 Device settings
54 FieldMan Narda
7.9.2 Switching on the device without a probe
connected
7.9.3 Switching on the device with a probe
connected
7.9.4 Probe change during operation
In the delivery state, the directories are empty. Measurement settings are saved to one
of the above directories whenever the instrument is turned off, a probe is disconnected
or unplugged, or the user saves the current measurement settings as a setup with the
probe connected.
The last general device settings used (see 7.3 GENERAL SETTINGS on page 45) are
also saved on the SD card when the device is switched off. Since the settings are
probe-independent, they are stored in the Device Settings directory. When the device
is switched on, these settings are loaded or – if the file is missing – the factory settings
are loaded.
Without a probe connected, only the probe-independent Last Device Settings are loaded.
The last measurement settings Last Settings are loaded only after a connected probe
has been detected.
After switching on the device, the last used device and measurement settings are
restored by loading the two settings files. If one of the files is not available, the factory
settings are loaded in
stead.
If a probe is unplugged while the device is running, the current measurement settings are
saved as Last Settings for this probe type. When reconnecting the same probe type, the
same Last Settings will be used. If another probe type is detected instead, the Last Set-
tings for this probe type will be loaded.

NARDA FieldMan Specifications

General

Brand	NARDA
Model	FieldMan
Category	Measuring Instruments
Language	English