NARDA FieldMan User Manual

8 Operating modes
84 FieldMan Narda
8.6.2 Numerical display
Time Span Time domain (X axis)
Single Run Measurement ends after set Time Span
1) The available parameters depend on the selected operating mode and the connected probe
type.
Two fields are available for numerical display:
• Main field: Displays current or static measured values, depending on the selected
result type and detection type, as well as the selected evaluation standard
• Supplementary field: Always displays static values
Detector
The Peak or RMS detector to be used is determined by the selected measurement
method (see 8.6.1 Measurement settings on page 83, Method).
Evaluation curve
The limits to be used for calculating the exposure index are determined by selecting a
standard (see 8.6.1 Measurement settings on page 83, Weighting).
Result type
The result types are always displayed in the supplementary field. To display them in the
main field, the result type must be selected in the selection field using the cross key.
Select a result type:
⇒ Press the ◄ ► keys repeatedly until the desired result type is displayed.
Detector
1)
Selection via
cross key
Main field Supplementary
field
Top Bottom
RMS +
Peak
ACTUAL ACTUAL X Y Z MAX, MIN
MINIMUM MIN ACTUAL
MAXIMUM MAX ACTUAL
1) In this mode of operation, the EHP-50F/G probe has only the Peak detector type,
on the EHP-50G the WPM option must be enabled.
Function
1)
Description

NARDA FieldMan Specifications

General

Brand	NARDA
Model	FieldMan
Category	Measuring Instruments
Language	English