Chapter 2 VirtualBench-Scope
© National Instruments Corporation 2-5 Getting Started with VirtualBench
Figure 2-2. General Tab of VirtualBench-Scope Settings Dialog Box
c. Click OK to use these settings.
Note When you launch VirtualBench-Scope, it automatically uses the settings of your
previous VirtualBench-Scope session.
3. Enable the button for the connected channel in the Channel Selector
group. Disable all other channels.
4. To start, click Auto Setup on the main control bar.
5. To change the trigger position, drag the trigger cursor (the small green
cursor in the center of the graph).
6. Click Run to stop the acquisition.
Note Refer to the VirtualBench-Scope Online Reference for information about
configuring VirtualBench-Scope for your specific application.
To Next Page
Loading...
