Chapter 3 VirtualBench-DSA
© National Instruments Corporation 3-3 Getting Started with VirtualBench
Acquiring and Measuring Signals
Complete the following steps to start acquiring and measuring signals with
VirtualBench-DSA:
1. Connect a signal to the Channel 0 or 1 input of your DAQ device. Refer
to the user manual of your DAQ device for details.
2. Configure the DSA.
a. Select Edit»Input Settings on the front panel.
b. Select the Input tab from the DSA Settings dialog box, shown in
Figure 3-2.
Figure 3-2.
Input Tab of DSA Input Settings Dialog Box
c. Select the device you want to use for the data acquisition. The
Device list displays only devices you have configured successfully
in the Measurement & Automation Explorer.
To Next Page
Loading...
