Chapter 5 VirtualBench-FG
© National Instruments Corporation 5-3 Getting Started with VirtualBench
Figure 5-2. VirtualBench-FG Settings Dialog Box
c. Set the Channel, Update Rate, Use FIFO, and Buffer Size
controls.
d. Click OK.
2. Connect a device or scope to the output of the analog output device that
you specified in Step 1. Refer to your DAQ device user manual or
instrument manual for details.
3. Click On. VirtualBench-FG continuously generates an analog
waveform at the output pin.
4. Click On again to stop the waveform generation.
Note Refer to the VirtualBench-FG Online Reference for more information about
configuring VirtualBench-FG for your specific application.
To Next Page
Loading...
