4. Press the right Page button to change the filter from PRODUCT to TYPES.
5. Turn Knob 1 until KITS is selected. This will reduce the results list on the right to display
only kits.
6. Turn Knob 2 until URBAN KIT is selected. This will further reduce the results list on the
right display to the kits of that type.
7. Under the right display, turn Knob 8 to scroll down the list until EK-TL A KIT is selected.
8. Now press SHIFT + Button 4 above the displays so that +PAT is deselected (the Button
must be off — this will be explained in more detail later).
9. Press the Control encoder or Button 8 (above the displays) to load the selected entry.
→
The drum kit is loaded into the first Group slot.
As last step, let’s leave the Browser and get back to the default Control mode of your control-
ler:
►
Press the lit BROWSE button to leave the Browser (the button is unlit).
That’s it! You just loaded a drum kit into a Group slot of MASCHINE. It is now ready to be
played from the pads, as you will see in the next section.
The process of loading from the Browser is the same for all kinds of objects: In the
Browser, after choosing the desired object, select the desired content, type, and sub-
type, then scroll through the result list and select an object for loading.
First Steps
Loading a Drum Kit from the Factory Library
MASCHINE - Getting Started - 24
To Next Page
Loading...
Need help?
General
