Native Instruments traktor kontrol s5 - FX Unit Assignment

Name Function in Single Mode Function in Group Mode
FX Knob 1 Adjust the ratio between the
unprocessed (dry) signal and
processed (wet) signal for the
entire FX Unit.
Adjust the ratio between the
unprocessed (dry) signal and
processed (wet) signal for the
entire FX Unit.
FX Knob 2 Controls FX parameter 1. Control the 1st effect in the FX
Unit.
FX Knob 3 Controls FX parameter 2. Control the 2nd effect in the FX
Unit.
FX Knob 4 Controls FX parameter 3. Control the 3rd effect in the FX
Unit.
4.3.1 FX Unit Assignment
In order to route a Deck's signal to an FX Unit, press the corresponding FX Assign button in the
mixer channel.
FX Assign Buttons
►
In TRAKTOR's default setup with 2 FX Units, press the left FX button to assign the mixer
channel to FX Unit 1. Press the right FX button to assign the channel to FX Unit 2. The
FX assign buttons light up bright orange when assigned.
Hardware Reference
The FX Unit
TRAKTOR KONTROL S5 - Manual - 166