3. Listen to the track playing in Deck A, and press the PLAY button of deck B on an appropri-
ate downbeat to start playback.
If your timing was perfect, a single orange LED at the center of the LED strip lights up,
indicating the phase-alignment of both tracks is correct.
If your timing was a little off, a few blue LEDs above the Touch Strip light up, indicating
the amount of phase-misalignment.
Second Step: Correcting phase-alignment
To correct the phase-alignment of both tracks, proceed as follows:
If blue LEDs are shown above the right side of the Touch Strip on the Deck not assigned to
MASTER:
►
Swipe your finger toward the left side of the Touch Strip until the blue LEDs disappear
and a single orange LED is shown.
If blue LEDs are shown above the left side of the Touch Strip on the Deck not assigned to
MASTER:
Using Your S5—Getting Advanced
Using Touch Strip
TRAKTOR KONTROL S5 - Manual - 71
To Next Page
Loading...
