Getting Started with MAXserver Access Servers
0038
113
Retrieving Image Files from Host
Use this command to retrieve a load image from a host on the LAN to a flash
card in an access server, either through TFTP or XMOP (use XMOP to get
the image from another NBase-Xyplex unit).
GET CARD LOAD FILE [
image-name
] ADDRESS [
ip-address
] AREA [
area-number
]
[
ether-address
] AREA[
area-number
]
"image-name" The name of the updated image file
ip-address The IP address where the image file is located
ether-address The Ethernet address where the image file is located.
area-number The area on the flash card where you want to store the file.
Example
GET CARD LOAD FILE "xpcsrv20.sys" 140.179.255.110 AREA 2
Terminating Image File Loading
Use this command to terminate the image loading update that was initiated
with the GET CARD LOAD FILE command.
XYPLEX>> GET CARD STOP
Dump Protocols
Use the following command to enable or disable dump protocols:
DEFINE SERVER DUMP [
RECORD
] PROTOCOL
PROTOCOL
|ALL
ENABLED|DISABLED
The [record ] variable specifies the primary, secondary, or tertiary
initialization record.
To Next Page
Loading...