NBase-Xyplex MAXserver 1608A - Displaying the Software Load Host; Displaying the Parameter Server; Figure 34 - Primary Initialization Record Display

Getting Started with MAXserver Access Servers
0038
118
Use the following command to display the current parameters:
LIST|MONITOR SERVER LOADDUMP [
RECORD
|ALL]
CHARACTERISTICS
Example
This sample display shows the primary initialization record.
XYPLEX> LIST SERVER LOADDUMP PRIMARY CHARACTERISTICS
Primary Record: Enabled
Internet Load Address 140.179.80.133
Internet Load Host 140.179.119.3
Internet Load Gateway 0.0.0.0
Internet Load File /usr/xyplex/images/xpcsrv20.sys
Software: XPCSRV20
Image Load Protocols Enabled: Card, XMOP, MOP, BOOTP, RARP, DTFTP
Dump Protocols Enabled: XMOP, MOP, BOOTP, RARP
Parameter Protocols Enabled: NVS, XMOP, MOP, BOOTP, RARP
Figure 34 - Primary Initialization Record Display
Displaying the Software Load Host
Use the following command to display the name and location of the software
load host, if the access server obtained the software load image from the
network.
SHOW/MONITOR SERVER STATUS
Displaying the Parameter Server
Use the following command to display the name and location of the
parameter server:
SHOW/LIST/MONITOR PARAMETER