Getting Started with MAXserver Access Servers
0038
55
Get File Name: Name of file.
Get File Area: Area of flash card to put file.
Get File Current
State:
What the card is currently doing.
Get File Previous
State:
Did previous GET FILE succeed.
Parameter Area
Updates:
How many times the PARAM Area of the Flash card
was updated since the server was rebooted.
Updating Images
You must re-initialize the unit after updating the
card, if you want to use the new software version
immediately.
Use the following command to initiate and terminate flash card load image
updates.
SET SERVER GET CARD [LOADFILE] [“
FILE-NAME”
] IP ADDRESS [
IP-ADDRESS
] AREA [
AREA-NUMBER
]
ETHERNET ADDRESS [
ETHER-ADDRESS
] AREA [
AREA-NUMBER
]
[STOP]
Where Means
LOADFILE Loads the image file.
"file-name” The image’s file name. Enclose the name in
quotes.
IP ADDRESS Location of stored file to GET.
STOP Terminates the file loading process.
ETHERNET ADDRESS Location of the stored file to GET
To Next Page
Loading...