NBase-Xyplex MAXserver 1608A - Command Line Interface

Getting Started with MAXserver Access Servers
0038
107
Command Line Interface
This section describes the commands you can use to configure the
MAXserver from the command line:
· Viewing Initialization Parameters
· Changing the name of the software image file
· Assigning IP addresses to the network host, access server, gateway, and
the network host where the image file resides
· Changing the Status of an Initialization Record
· Enabling and Disabling Protocols
· Resetting Parameters in Initialization Records to Default Values
See the Commands Reference Guide for a complete listing of all commands.
Displaying an Initialization Record
Use the following command to display an initialization record:
LIST SERVER LOADDUMP [
primary
] CHARACTERISTICS
[
secondary
]
[
tertiary
]