Getting Started with MAXserver Access Servers
0038
82
DEFINE SERVER LOAD STATUS MESSAGE [ENABLED]
[DISABLED]
Where
Means
ENABLED Status messages display during the loading process. This
is the default.
DISABLED Status messages will not display during the loading
process.
Example
DEFINE SERVER LOAD STATUS MESSAGE DISABLED
Loading Protocols
The default protocols are tried in the following order: Flash Card,, Directed
TFTP, XMOP, BOOTP/TFTP, MOP, and RARP/TFTP. The protocols are:
·
Flash Card - For MAXservers, use FlashCard (card) to load image only.
·
Use XMOP for loading from a NBase-Xyplex load server.
·
Use MOP for loading from a VAX/VMS host.
·
Use BOOTP, RARP, and DTFTP (Directed Trivial File Transfer Protocol)
for loading from a UNIX host. Typically, you only need to use DTFTP
when loading across a router or when the load host does not support
BOOTP or RARP.
You can change the default value for many prompts. The first time you run
the Configuration Menu, the default value shown is the factory default
value. After you exit from the Configuration Menu, having saved changes,
To Next Page
Loading...