Getting Started with MAXserver Access Servers
0038
14
Flash Card -- An optional card, from which the unit can load its operating
software.
The MAXserver can also load software from the flash card to other NBase-
Xyplex access server units on the network for which it has a load image.
Network Software Loading -- If you order a MAXserver without a flash
card, the unit loads its operating software from a network host called a load
server. The load server is typically a UNIX
Ô
or VAX/VMS
Ô
system.
However, you can also use a MAXserver Manager card (MAXman) or
another MAXserver. The load server downloads a software image to the
MAXserver over the network whenever the access server is powered on or
re-initialized. The load serverm can support other devices as well.
Expandable Memory – All MAXserver units are shipped with 4 MB of
factory installed memory. The memory can be expanded in 2 MB
increments, up to 8 MB, using SIMM memory modules. SIMMs should be
installed by qualified personnel only. To upgrade your MAXserver, contact
your NBase-Xyplex sales representative or distributor. Installation
instructions are provided later in this Guide.
Concurrent Flow Control and Modem Control Support -- The
MAXserver provides concurrent support for RTS/CTS flow control signals
and modem control; signals on all ports. Adapters are available to support
cabling to MAXserver ports when these signals are used. In most cases, the
MAXserver can also use standard MAXserver 1000-series cabling, if support
for the new signals is not required.
To Next Page
Loading...