0038
ix
Defining Dumping Methods
................................
................................
96
Defining IP Addresses
................................
................................
................................
99
Miscellaneous Unit Configuration
................................
................................
100
Resetting the Unit’s Load and Dump Protocols to Factory Defaults
102
Initializing Server and Port Parameters
................................
................................
104
Revert to Stored Configuration
................................
................................
104
Exit Saving Configuration Changes
................................
................................
105
Exit Without Saving Configuration Changes
................................
.........................
105
Command Line Interface..............................................................................107
Displaying an Initialization Record
................................
................................
107
Enabling/Disabling Image and Parameter Protocols
................................
109
Naming Load Files
................................
................................
................................
112
Retrieving Image Files from Host
................................
................................
113
Terminating Image File Loading
................................
................................
113
Dump Protocols
................................
................................
................................
113
Assigning IP Addresses
................................
................................
............................
114
Resetting Initialization Parameters To Default Values
................................
117
Displaying Initialization Parameters
................................
................................
117
Displaying the Software Load Host
................................
................................
118
Displaying the Parameter Server
................................
................................
118
Protocols
................................
................................
................................
119
Setting Up MaxServer Ports for Out-of-band Management of Console Port
Devices..........................................................................................................123
Accessing the Out-of-band Management Console Port ............................126
Accessing from an Ethernet-attached Station
................................
126
Accessing from a Dumb Terminal Attached to a MaxServer Serial Port
126
Troubleshooting...........................................................................................128
Startup/Loading Problems
................................
................................
128
Startup Error Codes
................................
................................
................................
129
Common Error Codes
................................
................................
...............................
131
Power Up and Re-initialization Problems
................................
..............................
132
Network Loading Problems
................................
................................
133
Loading Problems
................................
................................
................................
134
Load Server Errors
................................
................................
................................
135
SIMMs Installation........................................................................................142
Recommended SIMMs Manufacturers
................................
................................
142
MAXserver Memory Requirements
................................
................................
144
Installation
................................
................................
................................
144
Verifying Memory Installation Using Commands
................................
149
To Next Page
Loading...