NCR 7167 - Page 261

7167 Owner’s Manual Chapter 6: Commands
November 2003
248
Print Scanned Image GS ( G pL pH fn m (when fn = 68)
Command Description:
This command performs printing the scanned image data
ASCII GS ( G pL pH fn m
Hex 1D 28 47 pL pH fn m
Decimal 29 40 71 pL pH fn m
Range (pL + pH x 256) = 2 (pl = 2, pH = 0)
fn = 68
m = 48,49
Default m = 48
m Printing ratio of x direction
48 100% printing mode
if scan area width > printable width, the extra image is cut.
49 50% printing mode (Horizontal & Vertical direction)
This command is available on Black/White mode. (When scan mode is 8 bit gray scale, this
command is ignored.)
Execute Shading correction GS ( G pL pH fn m (when fn = 69)
Command Description:
This command performs Black/White shading correction.
ASCII GS ( G pL pH fn m
Hex 1D 28 47 pL pH fn m
Decimal 29 40 71 pL pH fn m
Parameter Value (pL + pH x 256) = 2 (pl = 2, pH = 0)
fn = 69
m = 48,49
Default m = 48
m Shading correction
48 Execute Black Shading correction
49 Execute White Shading correction