NCR 7167 - Chapter 5: Communication; Communication Overview and Interface; Sending Commands

7167 Owner’s Manual Chapter 4: Diagnostics
November 2003
63
Check Flip Test Mode
To run the Check Flip Test Mode:
1. Enable the Check Flip Test Mode through the Configuration Menu (See “Configuring
the Printer,” for instruction on how to enter the Configuration Menu), then exit the
Configuration Menu.
2. Insert a check as if validating the check, lengthwise and face down into the slip
station. (See “Verifying and Validating Checks” section to insert check.)
A check must be used – if any other slip or form is inserted the printer will not
conduct.
3. Push Paper Feed Button.
4. The check then goes through the flip routine only – no printing takes place.
To exit the Check Flip Test Model:
1. Enter the Configuration Menu again.
2. Disable the Check Flip Test Mode.
3. Exit the Configuration Menu
The printer is in Normal Mode and can communicate with the host computer.
Print Head Gap Adjustment Mode
Print Head Gap Adjustment Test Mode prints several lines of ‘H’ character. This is the slip
print testing during the print head gap adjustment. During adjustment, some covers will
be removed from the printer, even in this condition, slip printing need to be run when
paper is inserted. Print Head Gap Adjustment Test Mode is enabled and disabled using
the Configuration Menu.
To run the Print Head Gap Adjustment Test Mode:
1. Enable the Print Head Gap Test Mode through the Configuration Menu, (“See
Configuring the Printer,” for instructions on how to enter the Configuration Menu.
2. Insert a slip into the slip station.
Extended Slip
Table
LED
Guide