- 26-
TO PLACE A CALL ON HOLD
• Press Hold key. Held line wink flashes.
NOTE: If held line appears on other Dterm stations,
the associated LED flashes red slowly.
To retrieve:
• Lift handset or press Speaker key.
• Press held line. Use handset to converse.
NOTE: Any station with this line appearance can retrieve the call.
If unanswered:
• After preprogrammed time, Automatic Recall is initiated.
• Visual and audible signal (rapid flash and ring burst) is sent to station that
placed call on hold.
NOTE: Hold shows as a flashing green LED on your phone.
The same line on other phones shows as a flashing red LED.
Recall shows as a flashing green LED on your phone and
flashing red LED on other phones with the same line.
To Next Page
Loading...
Need help?
General
