NEC Express5800 120Rj-2 - Page 100

User Guide
100
www.nec-computers.com
*1Do not perform "Set Factory Defaults". If performed, the factory-set values can no
longer be restored.
Table 24: Default settings and their explanation
Item default Description Change
Battery Backup Present
None
Displays Properties.
When battery is installed: Present
When battery is not installed: None
–
Set Factory Defaults No
Yes
Restores vendor's factory defaults. Prohibited *1
Cluster Mode Disabled – Prohibited
Rebuild Rate 30 Recommended value: 30 Permitted
Patrol Read Rate 30 Recommended value: 30 Permitted
BGI Rate 30 Recommended value: 30 Permitted
CC Rate 30 Recommended value: 30 Permitted
Reconstruction Rate 30 Recommended value: 30 Permitted
Adapter BIOS Enabled
Disabled
– Prohibited
Coercion Mode None
128MB-way
1GB-way
– Prohibited
PDF Interval 300 – Prohibited
Alarm Control Disabled
Enabled
Silence
Disabled:Does not issue an alarm. Prohibited *2
Cache Flush Interval 4 – Prohibited
Spinup Drive Count 2 – Prohibited
Spinup Delay 12 – Prohibited
StopOnError Disabled
Enabled
– Prohibited
Stop CC On Error No
Yes
Specify the operation at error detection in
Consistency Check.
No: Recover and resume.
Yes: Abort
Permitted
Maintain PD Fail
History
Disabled
Enabled
– Prohibited
Schdule CC Supported Set the scheduled Consistency Check. Permitted