User Guide
45
www.nec-computers.com
Removal
Remove the server from the rack as described in the following procedure.
1. Make sure that the server is powered off, and disconnect the power cords and
all the interface cables from the server.
2. Unlock the front bezel with the security key.
Figure 19: Unlocking the Front Bezel
A: Security Key Hole
3. <This step is required only when the optional cable arm is mounted.>
Remove the cable arm from the server.
4. Push the left and the right unlock buttons on the front of the server, and pull out
the server from the rack slowly and carefully. The server clicks to unlatch.
Figure 20: Pushing the Unlock Button
A: Unlock button
2
1
A
A
To Next Page
Loading...