User Guide
242
www.nec-computers.com
Error Messages
Error Messages
If an error occurs in the server, an error message appears on the display unit connected
to the server.
Error Messages after Power-on
Powering on the server automatically starts the self-diagnostic program, POST (Power
On Self-Test). When the POST detects any error, it displays an error message and its
measure on the display unit.
Follow the table below to troubleshoot such errors. However, even when there is no
hardware failure, use of the keyboard or mouse at the following timing causes the
POST to assume a keyboard controller error and stop processing.
■ Immediately after the server is powered
■ Immediately after the system is rebooted in response to a keyboard instruction
(simultaneous key entry of
Ctrl + Alt + Delete)
■ Immediately after the system is rebooted in response to an OS instruction
■ During hardware initialization following restart of the POST
When the POST detects a hardware failure due to the above reason, restart the server
once again. If the same error message reappears, you may assume there is no hardware
error. To ensure normal operation of the server, however, make sure to follow the
following restrictions.
■ Do not make any keyboard entry or use the mouse before the memory count
appears on the screen following the server power-on.
■ Do not make any keyboard entry or use the mouse before the start-up message of
the SCSI Configuration Utility appears on the screen following the server reboot.
Note: Note the on-screen message before contacting your
sales agent. The alarm indication would be a great help for
maintenance.
To Next Page
Loading...