NEC Express5800 120Rj-2 - Parameter File Creator; Parameters File

User Guide
272
www.nec-computers.com
Parameter File Creator
"Parameter File Creator" is a tool to create the [Parameters file] that is used for
configuring the server with the Express Setup (see
“Appendix 5: Installing the
Operating System with Express Setup” on page 288 for details).
If you use the Parameters file created by the Express Setup and the Parameter File
Creator to operate the setup, the setup can be done automatically except for a few key
inputs to confirm the specification. You can also install the system with the same
specifications as before when re-installing the system. We recommend you create a
[Parameters file] to setup the servers from the NEC ExpressBuilder.
When using a floppy disk, a USB floppy disk drive is required.
Caution
You cannot create a [Parameters file] for Microsoft Windows
Server 2003 x64 Editions.
Note: You can install Windows Server 2003 without a
[Parameters file]. Also, you can modify/newly create
the[Parameters file] during the setup with the NEC
ExpressBuilder.
Parameters File
This section describes how to specify the setup information that is necessary for the OS
installation and creation using a Parameters File.
Follow the procedure below.
Caution
Do not remove the NEC ExpressBuilder DVD from the drive
during the parameters file creation.
1. Start the OS.
2. Insert the NEC ExpressBuilder DVD into the optical disc drive.
The menu appears.