User Guide
29
www.nec-computers.com
Remote Power-On Feature (Wake On LAN)
The remote power-on function turns on the server through the network. It sends a
special packet from a management computer to the remote server instructing it to turn
itself on if it is powered off.
To enable this feature, use the BIOS setup utility, "SETUP." (See “BIOS Setup Utility”
on page 64.)
The remote power-on feature is not available in the following cases. Press the POWER
switch once to start the OS, and turn off the server in an appropriate procedure.
■ Abnormal previous system shut-down
■ No power supply to the server (due to turned-off breaker, disconnected power cord,
power blackout, etc.)
AC-Link Feature
When the power cord of the server is connected to an uninterruptible power supply
(UPS) unit, the server supports the power linkage feature that enables control over the
power supply from the UPS to the server. The AC-Link feature can be enabled or
disabled with the Server menu of the BIOS setup utility, "SETUP." (See “BIOS Setup
Utility” on page 64.)
To Next Page
Loading...