NEC Express5800 120Rj-2 - Solving Problems; Error Messages on the Virtual LCD

User Guide
219
www.nec-computers.com
Solving Problems
Error Messages on the Virtual LCD
The NEC EXPRESSSCOPE Engine 2 (Remote Management Controller) on your
server board allows you to monitor the server status on the WEB browser-based screen
of the client PC via network.
The virtual LCD (16 digits x 2 lines) in the "Host Information" area displays the POST
codes and status message.
When POST detects an error, the POST error code is displayed on the virtual LCD
upon completion of POST. See the table for POST error codes for details.
Figure 186: Virtual LCD Screen
A: Message sent from BIOS
B: Message sent from BMC
C: Virtual LCD
D: Status indicators
Figure 187: BIOS Messages (Upper Line)
On-screen message Description Action
XX BIOS rev YYYY POST in progress.
XX: POST code, YYYY: BIOS
version
This is not an error.
CPU Reconfigured POST completes with processor
degraded.
Contact your service representative.
Try the following steps to cancel the
error.
1. Start BIOS SETUP.
2. Select [Main] - Processor Settings]
- [Processor Retest] - [Yes].
3. Select [Exit] - [Exit Saving
Changes].
POWER ON
ATTENTION
Virtual LCD
Status indicat
o
m
BIOS
m
BMC
A
B
C
D