User Guide
202
www.nec-computers.com
Installation (USB File Devices)
1. See the section “Preparing Your System for Upgrade” on page 137.
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See “Drive Cover” on page 141 and
“Logic Cover” on page 143.
4. Remove the PCI riser module. See “Installing and Removing a PCI Board” on
page 166.
5. Remove the support arm from the chassis.
Figure 168: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Press firmly the support arm before removing the screws.
6. Remove the processor duct from the chassis.
Figure 169: Removing the Processor Air Duct
To Next Page
Loading...