User Guide
213
www.nec-computers.com
Resetting the Server
There are two ways to reset the server.
Caution
Resetting the server clears the DIMM memory and the data in
process.
To reset the server when it is not frozen, make sure that no
processing is in progress.
■ Hard reset
Press the power switch at the front of the server. (see
“Forcing a Power Shutdown” on
page 58)
Caution
If the remote power-on function is used, cycle the power once to
load the OS, and turn off the power again in the normal way.
If the processor is heated excessively, the circuit for protecting
expensive components is activated. If so, the POWER/SLEEP
switch cannot be used to control the power because the system
is entered into the reset status. Pull out the power cord and turn
off the power. After a while, check the operation environment
(including the ambient temperature). Then connect the power
cord and turn on the power. Wait a while before powering the
system on again.
■ Soft reset
If the server halts before starting the OS, press and hold
Ctrl and Alt and press Delete.
This restarts the server.
To Next Page
Loading...