User Guide
107
www.nec-computers.com
Configuring a Virtual Disk
This section describes the procedures for the configuration of a VD (virtual disk) using
WebBIOS.
Configuration Wizard
When you click [Configuration Wizard] on the WebBIOS Top Menu, the screen shown
below is displayed. Select the relevant operation, and click [Next] at lower right of the
screen.
Figure 51: Configuration Wizard Screen (1)
Clear Configuration Allows you to clear existing configuration.
New Configuration Clears the existing configuration and creates a new VD. If you have
any existing data in the virtual disk defined earlier, the data will be lost.
Add Configuration Retains the old configuration and then adds a new virtual disk.
To Next Page
Loading...