User Guide
327
www.nec-computers.com
9. When prompted to do so, press Enter to start the "Welcome to Setup" wizard.
Once the installation of Windows Server 2003 is finished, the system reboots
automatically.
■ Windows Server 2003: go to step 13.
■ Windows Server 2003 R2: go to step 10.
10. Log on to the system, the [Windows Setup] screen is displayed.
Figure 195: Windows Setup Screen
Caution
■ In some cases, the [Windows Setup] screen may not be dis-
played.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
■ You can install Microsoft Windows Server 2003 R2 DISC 2
after the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 DISC
2. In this case, note that the [Windows Setup] screen is not
displayed.
11. Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the optical
disc drive. Confirm the parameters and click [OK].
12. When the installation has completed, remove Microsoft Windows Server 2003
R2 DISC 2 CD-ROM from the optical disc drive, and restart the system.
13. Once the installation is completed, execute the tasks described in “Driver
Installation and Device Settings” on page 333 and “Updating System” on
page 320.
Procedure for License Authentication
The Product Key used in the procedure for license authentication must match with the
COA label.
To Next Page
Loading...