User Guide
159
www.nec-computers.com
14. Start the SETUP and select [Advanced] → [Memory Configuration] to verify
that the installed DIMM shows the status "Normal". (See
“BIOS Setup Utility”
on page 64 or details.)
15. Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See
“BIOS
Setup Utility” on page 64 for details.
16. If the Windows operating system is in use, set the paging file size to the
recommended value (total memory size × 1.5) or a greater value.
Removal
Remove the DIMM according to the following procedure.
Notes:
■ To remove the failed DIMM, check the error message
appearing in POST or NEC ESMPRO to identify the DIMM
socket (group) in which the failed DIMM is installed.
■ The server operates only when at least two DIMMs are
installed.
1. See the section “Preparing Your System for Upgrade” on page 137 to prepare.
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See “Drive Cover” on page 141 and
“Logic Cover” on page 143.
4. Remove the PCI riser module. See “Installing and Removing a PCI Board” on
page 166.
5. Remove the two screws securing the support arm.
6. Remove the support arm from the chassis.
Figure 112: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Press firmly on the support arm to remove the screws.
To Next Page
Loading...