User Guide
82
www.nec-computers.com
Exit Menu
Caution
For the 3.5-inch disk model, record the current SATA controller
options in the Peripheral Configuration page of the Advanced
menu before reloading the Setup or custom defaults. The SATA
controller options affect the RAID System configuration.
You can make the following selections on the Exit Menu. Select an option using the up
or down arrow keys, then press <Enter> to execute the option. Pressing <Esc> does
not exit this menu. You must select one of the items from the menu or menu bar to exit.
Table 21: Exit Menu
Choices Description
Exit Saving Changes Exits after writing all modified Setup item values to NVRAM.
F10 key can be used for this operation.
Exit Discarding Changes Exits leaving NVRAM unmodified. User is prompted if any of
the setup fields were modified.
Esc key can be used for this operation.
Load Setup Defaults Loads default values for all SETUP items.
F9 key can be used for this operation.
Load Custom Defaults Loads the custom defaults for the BIOS Setup options.
Save Custom Defaults Saves the current values as custom defaults. This menu is
only available once the Load Custom Defaults option has
been used.
Discard Changes Read previous values of all Setup items from NVRAM.
Save Changes Save changes to NVRAM without exiting the Setup.
To Next Page
Loading...