User Guide
152
www.nec-computers.com
Notes:
■ Make sure the support arm holds the processor duct firmly
(see figure below)
■ Loosen the screws when the support arm comes up. Press
firmly the support arm before removing the screws.
Figure 104: Routing the cable
A: Support arm
B: Processor duct
22. Install the covers you removed previously.
23. Power on the server, start the SETUP utility, and set "Processor Retest" of
"Processor Settings" on the Main menu to "Enable".
24. Set "Reset Configuration Data" on the Advanced menu to "Yes".
This setting is required to change the hardware configuration data. See
“BIOS
Setup Utility” on page 64 for details.
25. Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the
POST error messages listed in
“POST Error Messages” on page 200.
26. When adding an additional CPU to a computer running the Windows operating
system, change the driver of [Computer] in the Device Manager to [ACPI
multi-processor PC] and then update the system.
A
B
To Next Page
Loading...