User Guide
168
www.nec-computers.com
pushing the catch with a standard screwdriver. At this time,
be very careful for the screwdriver not to damage the LAN
port or other ports.
■ If a bootable PCI board (e.g., a RAID controller, SCSI con-
troller, or LAN card) is additionally installed, the boot priority
is changed from the default. After the additional installation,
start the BIOS SETUP utility, select [Boot] → [Boot Device
Priority], and set the new boot priority.
■ If an option operating with only 33 MHz is installed in one of
the slots (1C, 2C, and 3C, or 1B, 2B, and 3B) on a PCI riser
card, the options installed in the other slots of the same riser
card are subjected to operation with only 33 MHz.
■ Contact your service representative for the acceptable
optional PCI board.
To Next Page
Loading...