User Guide
177
www.nec-computers.com
2. Unlock of the front bezel with the security key and remove the front bezel.
3. Locate the slot in which you are going to install the hard disk drive. Follow an
ascending order.
4. Remove the drive carrier.
■ Unlock the hard disk drive handle.
Figure 130: Unlocking the hard disk drive handle
■ Pull out the drive carrier from the chassis.
5. Secure a hard disk drive into the carrier with four screws (one at the front and
one at the back on both sides).
6. With the handle fully open, hold the drive carrier and handle, and isert it into
the chassis.
Caution
■ Do not push on the handle until the handle begins to close
by itself.
■ Carefully hold the hard disk drive with both hands.
To Next Page
Loading...