User Guide
193
www.nec-computers.com
Notes:
■ Be sure to use the screws provided with the backup device.
■ Position the backup device so that the device screw holes
align with the screw holes in the device carrier.
■ If you find it difficult to connect the cable of a long device,
slide the device to the front in order to connect the cable.
11. Connect the power cable and interface cable to the device.
Figure 149: Connecting the Cables to the Backup Device
A: Power cable
B: IDE cable
Note: Connect the connector marked with "TAPE" of the
power cable to the power connector on the device.
12. Insert the device carrier into the backup device bay halfway.
Figure 150: Inserting the Backup Device Carrier
Note: Be careful not to damage the connected power cable
when inserting the device carrier.
A
B
To Next Page
Loading...