User Guide
200
www.nec-computers.com
17. Connect the power cable to the backplane as shown in figure below.
Figure 164: Connecting the Cables to the Backplane
Note: Place the terminator at the end of the SCSI cable in
the device bay. At this time, also confirm that the SCSI cable is
not in contact with the latching tab of the device carrier. This
prevents the cable from being damaged.
Figure 165: SCSI Cable and Terminator Placement
A: SCSI terminator
B: IDE connector
C: Latching tab
D: SCSI cable
A
B
C
D
To Next Page
Loading...