User Guide
231
www.nec-computers.com
- The internal LAN controller may be disabled with the CMOS Setup utility of
the server. Check the setting with the BIOS setup utility.
■ Have the protocol and service already configured?
- Install the distinctive network driver for the server. Make sure that the protocol,
such as TCP/IP, and services are properly specified.
■ Is the transfer speed correct?
- Open the network property dialog box in control panel to specify the link speed
and duplex value the same as the value specified for HUB.
■ The Telnet Service is not installed.
- Adjust the computer name to 14 characters or less, and then install the Telnet
Service as described below:
1. Click [Run] on Start menu.
2. Type "tlntsvr /service" in the [Open] box, and click [OK].
3. Click Start menu, point to [Control Panel] and click [Computer Management]
and then click the [Services] to specify whether the Telnet Service is registered.
Once the installation of Telnet Service is finished, you can reset the computer
name to 15 characters or more.
Power ON/OFF (Wake On LAN) feature does not work:
Immediately after the AC power is turned on, the Remote Power ON/OFF feature
(Wake ON LAN) is disabled. Start Windows 2003 once, provide the settings shown
below, then shutdown the system.
After restart, the Remote Power On/Off feature will be available except when the AC
power is turned off.
1. Select [Start] → [Administrative Tools] → [Computer Management].
2. Select Device Manager, double-click [Intel(R) PRO/1000EB Network
Connection with I/O Acceleration #n] under Network Adapter, and specify as
follows in [Detail] tab.
PME: [ON]
Wake On:[ Magic Packet]
Fail to start the OS with the /3GB switch
System often fails to start the OS with the /3GB switch.
In this case, please adjust the capacity of the user mode area using the /userva switch in
reference to the following URL.
http://support.microsoft.com/kb/316739/en
To Next Page
Loading...