User Guide
350
www.nec-computers.com
Note: If you install your system using the Windows CD-
ROM that contains the Service Pack 2, you do not have to apply
the Service pack 2 again.
1. Log on to the system using an account administrator authority (such as
administrator).
2. Insert the NEC ExpressBuilder DVD into the optical disc drive.
The Autorun Menu is displayed
3. Left-click on [Setup Windows], and then click [Update the system].
Note: You can also right-click on the Autorun Menu.
Follow the on-screen messages to proceed. The [OK] dialog box is displayed.
4. Click [OK] to restart the system.
When the reboot starts, immediately remove the NEC ExpressBuilder DVD
from the optical disc drive.
Caution
During the "Updating the System", the following message may
be shown, but there is no impact to the operation. Do not click
[cancel] since it may be taken away after a few seconds.
To Next Page
Loading...