User Guide
94
www.nec-computers.com
■ Creation of virtual disks
- RAID level Settings
- Stripe Block size Settings
- Read Policy/Write Policy/IO Policy Settings
■ Indication of the configuration information and status of the virtual disk
■ Virtual Disk removal
■ Configuration clearing
■ Initialization
■ Consistency Check
■ Manual Rebuild
■ Reconstruction
Notes on when creating a Virtual Disk
■ The HDDs configuring the disk group should have the same capacity and rotation
speed.
■ Be sure to execute a Consistency Check after the VD creation.
■ When installing an OS in VD under the Internal RAID Controller, create a VD
dedicated to the OS installation.
■ WebBIOS cannot be handled via the remote console functions of NEC
DianaScope.
■ The physical drive numbers shown in WebBIOS and those shown in the Universal
RAID Utility are identified as follows.
-WebBIOS
Enclosure number and Slot number shown in the Physical Drives box*
*"X:X:X" shown in the Physical Drives box represents the Connector
number:Enclosure number:Slot number.
- The Connector number is not supported on this server, thus, it is always
indicated as "()".
- The Enclosure Number is always "1".
- The Slot number represents a slot number of disk bay.
- Universal RAID Utility
The Enclosure number and Slot number are shown in the Physical Device
Properties
To Next Page
Loading...