NEC SL1100 - Upload; Accessing Upload

A - 10
___________________________________________________________________________________
___________________________________________________________________________________
Issue 3.01 NEC SL1100
5. After the download is completed, press the Close button.
3.2.1 Transfer Type
Select a filter that controls the scope of settings to download. The
following Transfer Types are made available.

All: No filter, all chassis settings.
 Blade Configuration: Blade package settings.
 System Data Partial (System Wide): System-based settings.
 System Data Partial (Telephone): Telephone-based settings.
 System Data Partial (Virtual Extension): Virtual Extension-based
settings.
 System Data Partial (Trunk): Trunk-based settings.
 User Data: User-specific settings.
Transfer Type Items
Specifically select PRG Groups and/or individual PRGs from the
chassis settings to download. The choice of Transfer Type Items
available is governed by the Transfer Type selected.
Modify Filters
A filter is applied based on the system data modification status. The
filter only applies to system data on the PCPro side, not system data
residing in chassis memory. Refer to Appendix C - Modification
History for further information.
SECTION 4UPLOAD
Uploading pushes all the data from PCPro to system memory. An upload can only
occur when PCPro is connected to a system.
4.1 Accessing Upload
When PCPro is connected to a system, access the Upload dialog using one of
the following methods:
 Select the menu item Ribbon Item Home > Upload.
or…
 Select the icon depicting the red arrow .
or…