NEC SL1100 - Figure B-4 Multiassign - Extension Numbers Example

B - 6
___________________________________________________________________________________
___________________________________________________________________________________
Issue 3.01 NEC SL1100
3. When the new “MultiAssign” icon is pressed in System/Numbering/Stations, a
screen similar to the one below will be presented. Note the default ports for
extension assignment is 1~128.
1. Select drop down to select the Extension type.
2. Assign the beginning port number.
3. Assign the ending port number.
4. Assign the first Extension in the range.
5. Click Apply.
Figure B-4 MultiAssign - Extension Numbers Example
1) Drop down to select extension type
2) Beginning station port
3) Ending station port
4) The first station number
5)Click Apply