NEC SL1100 - Uploading Blade Configuration; Figure A-12 Trunk Ports Busy Warning

A - 12
___________________________________________________________________________________
___________________________________________________________________________________
Issue 3.01 NEC SL1100
4.2.1 Transfer Type
Select a filter that controls the scope of chassis settings to upload.
The following Transfer Types are made available.

All: No filter, all Chassis settings.
 Blade Configuration: Blade packages settings.
 System Data Partial (System Wide): System-based settings.
 System Data Partial (Telephone): Telephone-based settings.
 System Data Partial (Virtual Extension): Virtual Extension-based
settings.
 System Data Partial (Trunk): Trunk-based settings.
 User Data: User-specific settings.
Transfer Type Items
Specifically select PRG Groups and/or individual PRGs from the
chassis settings to upload. The choice of Transfer Type Items
available is governed by the Transfer Type selected.
Modify Filters
A filter is applied based on the system data modification status. The
filter only applies to system data on the PCPro side, not system data
residing in chassis memory. Refer to Appendix C - Modification
History for further information.
4.3 Uploading Blade Configuration
When uploading the Blade Configuration via Upload All, and selecting Card
Configuration, or just Uploading Card Configuration, a warning popup will
display when either Trunks or stations are busy at the time of selecting to
uploading the Card Configuration. This will allow for the upload to be
cancelled and completed at a later time, or to be continued and will disconnect
the busy trunks and/or stations.
This popup is shown when the Card Configuration is selected to be uploaded
and the trunks are busy.
Figure A-12 Trunk Ports Busy Warning