E - 2
___________________________________________________________________________________
___________________________________________________________________________________
Issue 3.01 NEC SL1100
SECTION 2LAUNCHING THE DEBUG TERMINAL
You can launch the debug terminal in one of two ways:
Select the menu item Ribbon item Home > Debug Terminal.
or…
Click on the DbgTerm icon on the toolbar .
If PCPro is connected via LAN to a chassis, then the debug terminal automatically
tries to connect to the same IP address (domain name). Once the debug terminal is
running, incoming debug messages from the chassis appear on the screen. You can
capture the incoming data to a file by specifying a log file name and enabling the log
capture.
Log capture can be enabled or disabled at the your discretion. A message is printed in
the log file indicating the date and time the capture was enabled or disabled.
To Next Page
Loading...
