5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the passwords, use
90-02 : Programming Password Setup.
Program Mode
Base Service OP1 OP2
Digital (2W) Multiline Terminal, IP Multiline Terminal
Password User Name Level Programs at this Level
12345678 tech 2 (IN) Installation (IN) :
IN, SA and SB levels defined by 90-26 are available.
0000 ADMIN1 3 (SA) System Administrator - Level 1 (SA) :
10-27, 20-16, 20-34, 20-63, 20-64, 21-07, 21-14, 22-04, 22-11, 22-17,
25-08, 30-03, 30-04, 32-02, 41-02, 41-03, 41-04, 41-05, 41-06, 41-07,
41-08, 41-09, 41-11, 41-12, 41-13, 41-14, 41-15, 41-16, 41-17, 41-18,
41-19, 41-20, 45-02, 84-16, 84-22, 90-03, 90-04, 90-06, 90-07, 90-16,
90-19, 90-57, 90-58, 90-59, 90-65, 90-70, 93-01, 93-02, 93-03, 93-04,
93-05, 93-06
9999 ADMIN2 4 (SB) System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 15-14, 21-20
SECTION 5 HOW TO EXIT PROGRAMMING MODE
To exit the programming mode :
When you are done programming, you must be out of a program option to exit (pressing the Mute key
will exit the program option).
1. Press Mute key to exit the program options, if needed.
Program Mode
Base Service OP1 OP2
Digital (2W) Multiline Terminal, IP Multiline Terminal
2. Press Speaker. If changes were to the system programming, "Saving System Data" is displayed.
3. The display shows "Complete Data Save" when completed and exits the telephone to an idle
mode.
To save a customer’s database, a blank SD Card is required. Insert the SD Card into the CPU and, using
Program 90-03, save the software to the SD Card. (Program 90-04 is used to reload the customer data if
necessary.) Note that a SD Card can only hold one customer database. Each database to be saved requires
a separate drive.
ISSUE 1.0 SL2100
ACD Installation Manual 4-3
To Next Page
Loading...
