NEC SL2100 - Section 6 USING KEYS to MOVE AROUND in the PROGRAMS

CPU board
Blank SD Card
SD slot (J12)
SECTION 6 USING KEYS TO MOVE AROUND IN THE PROGRAMS
Once you enter the programming mode, use the keys in the following chart to enter data, edit data and
move around in the menus.
Table 4-1 Keys for Entering Data (Digital (2W) Multiline Terminal, IP Multiline Terminal)
When you want to ... Telephone Programming
Enter Data into program 0 ~ 9,
*
, # Line Key (1 ~ 6)
Next Index Cursor Key (Up)
Prior Index Cursor Key (Down)
Select Data Line Key (1 ~ 6)
All Clear Flash
Apply Hold
Enter
Go Back to Prior Screen Mute
Clear / Back
Move Cursor Jump Up/Down DND
Delete single character Clear / Back
Next Page Help
Toggle between Number/Character
While in a Entering Number
Prior Page Transfer
Quit the programming Speaker
Exit
Move Cursor to Left Cursor Key (Left)
Soft Key1
Change Program Number Soft Key2
Change Index Number
Change Program Number Soft Key3
Change Index Number
Move Cursor to Right Cursor Key (Right)
Soft Key4
SL2100 ISSUE 1.0
4-4
PROGRAMMING