NEC SL2100 - Incoming Virtual Extension Ring Tone Setup; Table 4-6 Program 15-08 - Incoming Signal Frequency Patterns

Program 15 : Extension, Basic Setup
15-08 : Incoming Virtual Extension Ring Tone Setup
Level:
IN
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a ring tone range (0 ~
8) to incoming virtual extensions assigned to a Virtual Extension key (Program 15-07). If you enable
ringing for the key in Program 15-09, the key rings with the tone you set in this program. Also see
Program 22-03. The chart below shows the available tones. There are 128 available extension ports.
Input Data
Extension Number Maximum eight digits
Item
No.
Item Input Data Description Default
01 Incoming Ring Pat-
tern
0 ~ 8
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming extension
ring tone
5 = Melody1 (2W
Digital/IP Multiline Termi-
nal)
6 = Melody2 (2W
Digital/IP Multiline Termi-
nal)
7 = Melody3 (2W
Digital/IP Multiline Termi-
nal)
8 = Melody4 (2W
Digital/IP Multiline Termi-
nal)
When an extension or a virtual extension
is assigned to the function key on the key
telephone, select the ring tone when re-
ceiving a call on that key.
0
Table 4-6 Program 15-08 - Incoming Signal Frequency Patterns
Incoming Signal Type Frequency 1 Frequency 2 Modulation
Pattern 1 High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
16 Hz
16 Hz
16 Hz
Pattern 2 High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
8 Hz
8 Hz
8 Hz
Pattern 3 High
Middle
Low
2000 Hz
1400 Hz
1100 Hz
760 Hz
660 Hz
540 Hz
16 Hz
16 Hz
16 Hz
Pattern 4 High
Middle
Low
2000 Hz
1400 Hz
1100 Hz
760 Hz
660 Hz
540 Hz
8 Hz
8 Hz
8 Hz
ISSUE 1.0 SL2100
ACD Installation Manual 4-25
Program
15