NEC SL2100 - Page 81

6.5 SIP NAPT Router Setup
Program/Item
No.
Description/
Selection
Assigned Data Comments
10-12-07 CPU Network Setup – NAPT
Router IP Address
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
Default is 0.0.0.0
Set the NAPT Router IP address.
With SIP trunking, the IP address
of the WAN side of the router
must be entered.
10-12-08 CPU Network Setup – ICMP
Redirect
0 = Disable
1 = Enable
Default is 0
Enable/Disable ICMP (Internet
Control Message Protocol) Redi-
rect.
6.6 SIP System Interconnection Setup
Program/Item
No.
Description/
Selection
Assigned Data Comments
10-23-01 SIP System Interconnection
Setup – System Interconnec-
tion
0 = Disable
1 = Enable
Default is 0
Enable/Disable system intercon-
nection.
10-23-02 SIP System Interconnection
Setup – IP Address
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
Default is 0.0.0.0
Define the IP address of another
system.
10-23-04 SIP System Interconnection
Setup – Dial Number
Up to 12 digits (0 ~ 9)
Default not assigned
Determine another system call
control port number.
6.7 SIP Protocol
Program/Item
No.
Description/
Selection
Assigned Data Comments
84-14-06 SIP Trunk Basic Information
Setup – SIP Trunk Port Num-
ber
1 ~ 65535
Default is 5060 = Profile 1
5062 = Profile 2
5090 = Profile 3
5092 = Profile 4
5094 = Profile 5
5096 = Profile 6
Select SIP Profile 1-6.
Set the SIP UA (User Authorized)
Trunk port number (Receiving
Transport for NEC SL2100 SIP).
84-14-07 SIP Trunk Basic Information
Setup – Session Timer Value
0 ~ 65535 seconds
Default is 0
Select SIP Profile 1-6.
Set the Session Timer Value.
0 means session timer is Off
84-14-08 SIP Trunk Basic Information
Setup – Minimum Session Tim-
er Value
0 ~ 65535 seconds
Default is 1800
Select SIP Profile 1-6.
Set the Minimum Session Timer
Value.
84-14-09 SIP Trunk Basic Information
Setup – Called Party Informa-
tion
0 = Request URI
1 = To Header
Default is 0
Select SIP Profile 1-6.
Set the Called Party Information.
ISSUE 1.0 SL2100
Networking Manual 7-13