Chapter 6: Component Locations 175
Component
Locations on
the E2660
Controller-Drive
Tray
The E2660 controller-drive tray is available in two different controller configurations:
simplex and duplex.
Keep these points in mind when you compare the figures in this section to your
hardware.
The top of the controller-drive tray is the side with the labels.
The configuration of the host ports depends on which host interface card
configuration is installed.
The figures in this section show the AC power option.
NOTE On the E2660 controller-drive tray, each controller
NOTE has a pair of levers with handles for removing the controller from the
controller-drive tray. If a controller has a HIC installed, one of these handles on the
controller is located next to a host port on the HIC. The close spacing between the
handle and the host port might make it difficult to remove a cable that is attached to the
host port. If this problem occurs, use a flat-blade screwdriver to compress the release
on the cable connector.
Figure 22 E2660 Controller-Drive Tray – Front View
1. Drive Drawer
2. Standby Power LED
3. Power LED
4. Over-Temperature LED
5. Service Action Required LED
6. Locate LED
To Next Page
Loading...
