NETGEAR GS108T-200NAS

GS108T and GS110TP Smart Switch Software Administration Manual
Configuring Quality of Service 4-23
v1.0, April 2010
Service Configuration
Use the Service Configuration page to activate a policy on an interface.
To display the page, click QoS  DiffServ  Advanced  Service Configuration.
To configure DiffServ policy settings on an interface:
1. To configure DiffServ policy settings for a physical port, click PORTS.
2. To configure DiffServ policy settings for a Link Aggregation Group (LAG), click LAGS.
3. To configure DiffServ policy settings for both physical ports and LAGs, click ALL.
4. Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the heading
row to apply the same settings to all interfaces.
5. To activate a policy for the selected interface(s) select the policy from the Policy In menu, and
then click Apply.
Figure 4-13