GS108T and GS110TP Smart Switch Software Administration Manual
Monitoring the System 6-15
v1.0, April 2010
Memory Logs
The in-memory log stores messages in memory based upon the settings for message component
and severity. Use the Memory Logs page to set the administrative status and behavior of logs in the
system buffer. These log messages are cleared when the switch reboots.
To access the Memory Log page, click the Monitoring Logs tab, and then click the Memory
Log link.
To configure the Memory Log settings:
1. Use the radio buttons in the Admin Status field to determine whether to log messages.
• Enable: Enables system logging.
• Disable: Prevents the system from logging messages.
2. From the Behavior menu, specify the behavior of the log when it is full.
• Wrap: When the buffer is full, the oldest log messages are deleted as the system logs new
messages.
Figure 6-5
To Next Page
Loading...
