GS108T and GS110TP Smart Switch Software Administration Manual
1-12 Getting Started
v1.0, April 2010
Firmware Upgrade
The application software for the GS108T and GS110TP Smart Switches is upgradeable, enabling
your switch to take advantage of improvements and additional features as they become available.
The upgrade procedure and the required equipment are described in this section. This procedure
assumes that you have downloaded or otherwise obtained the firmware upgrade and that you have
it available as a binary file on your computer. This procedure uses the TFTP protocol to implement
the transfer from computer to switch.
To upgrade your firmware:
1. Click the Maintenance tab, and then click the Firmware link directly below the tabs (see
Figure 1-1 on page 1-3).
2. Select the switch to upgrade and click Download Firmware.
3. From the Select new firmware window that appears, navigate to and select the firmware
image to download to the switch.
4. Click Open.
5. Enter the switch password to continue downloading the firmware.
6. Click Apply to download the firmware and upgrade the switch with the new image.
Note: Click the Tasks tab to view status information about the configuration download.
Note: You can also upgrade the firmware using the TFTP Download and HTTP
Download features mentioned in this book. See “Download File To Switch” on
page 7-5.
To Next Page
Loading...
